1.5V 1200mAh LR6 AAA Alkaline Battery used for remote control/ toy/ calculator/shaver etc..Send Inquiry
LR03 ALKALINE BATTERY
This specification defines the SUM for high Capacity Alkaline cells LR03 1.1 Type
1.2 Reference standard
IEC 60086-1--- Primary Batteries - Part 1: General
IEC 60086-2--- Primary Batteries - Part 2: Physical and electrical specification
1.3 Execution standard GB/T 8897.2
2． Chemistry composition
Zinc ,EMD , Potassium hydroxide, Graphite
0.00% Mercury & Cadmium
4.Average weight: 11.3g
1200mAh (condition: 75Ωloadresistance, discharge 4 hours per day at 20+/-2°C,
end-point voltage 0.9V )
（Test condition：Load Resistance ( ±0.5%) 3.9Ω，Time：0.3s, Temperature：20±2℃。）
7． Service Life
（Test condition: 20℃±2℃ and 60±15%RH）
Inspection Method/Satisfaction Standard：
1) 9 pieces of battery will be tested for each discharging standard
2) The result of the Minimum Average Duration from each discharging standard shall be equal to or more than the Minimum Average Duration requirement; and no more than
one battery has a service output less than 80% of the specified requirement.
3) One re-test is allowed to confirm the previous result
8． Leakage Resistance
9． Safety performance
The label printing:
（5）Warning：Battery may explode or leak if recharged or disposed of in fire。
11. Caution for use：
(1) Since the battery is not manufactured for recharging, there are risks of electrolyte leakage or
causing damage to the device if the battery is charged.
(2)The battery shall be installed with its "+" and "-" polarity in correct position, otherwise may cause short-circuit
(3)Short-circuiting, heating, disposing of into fire and disassembling the battery are prohibited.
(4 )Battery cannot be forced discharged, which lead to excess gassing and, may result in bulging, Leakage and de-crimping of cap.
New and used batteries cannot be used at the same time, when replaced batteries recommend to replace all and with the same brand type.
(6) Exhausted batteries should be removed from compartment to prevent over-discharge,
Which cause leakage damage to the device.
(7)Direct soldering is not allowed, which will damage the battery
(8)Battery should be kept out of the reach of children to prevent swallow, in case of accident should contact physician at once.
12． Period of validity： 3 years after delivery under proper storage conditions.
(Temperature: 20+/-2°C; Relative humidity: 65+/-20%RH)
13． Discharge curve
Figure 1: LR03, DISCHARGE CURVE
Discharge Method: 75Ω Period: 4 h/d Temperature: 20+/-2°C
Terminal Voltage (V)
Figure 2: LR03, DISCHARGE CURVE
Discharge Method: 10 Ω; Period: 1 h/d Temperature: 20+/-2°C.
Terminal Voltage (V)